Mini Mono 80*45MM Solar Panel 5V 75MA for charging and generating electricity with lipo charger

Products > Other > Mini Mono 80*45MM Solar Panel 5V 75MA for charging and generating electricity with lipo charger

Mini Mono 80*45MM Solar Panel 5V 75MA for charging and generating electricity with lipo charger

Feture:

Voltage:5V

Current: 75MA

Process: Epoxy

Material: high rate solar cell epoxy resin AB glue, PCB or fiberglass backplane

Size: 80*45MM
shared:



This is a supper mini Solar Lipo charger based on the CN3065 - a single
lithium battery charge management chip.

This Solar charger provide you with the ability to get the most possible power out of your solar panel or other photovoltaic device
and into a rechargable LiPo battery. Set-up is easy as well, just plug your solar panel into one side of the Solar charger and your
battery into the other and you are good to start charging! The output of the Solar Charger is intended to charge a single polymer
lithium ion cell. The load should be connected in parallel with the battery. By default, the Solar charge comes set to a maximum
charge current of 500mA with a maximum recommended input of 6V (minimum 4.4V). It's recommended that batteries not be charged
at greater than their capacity rating.

Features:

Solar panel input: 4.4-6V

Max charge current: 500Ma

Interface: 2-pin JST connectors(or PH2.0)

Short circuit protection

Continuous Charge Current Up to 500mA

Battery status indication ( Red : Charging , Green: Charged )

Micro-USB Connector

 

 

Pacakge A include

1*Solar panel

1* Solar Lipo Charger Board

3* Connetor Wire




Name
Phone
Email
Corporate name
Address
Leaving Message*
 
Verification code
Submit