Search

Smart Electronics KY-013 3PIN Analog temperature sensor module KY-013

Products > Module > Smart Electronics KY-013 3PIN Analog temperature sensor module KY-013
    • 1
    • 2
    • 3
    • 4
    • 5

Smart Electronics KY-013 3PIN Analog temperature sensor module KY-013

KY-013 3PIN Analog temperature sensor module KY-013
shared：


KY-013 Analog Temperature Sensor Module


This module works based on a thermistor (whose resistance value changes with the ambient temperature), which knows

the real-time changes in the surrounding temperature. We send the data to the microcontroller to simulate I0, and then

through simple programming, we can convert the sensor output data into Celsius temperature values and display them.

Easy to use, simple and effective, making it widely used in gardening, home alarm systems, and other devices.


Name
Phone
Email
Corporate name
Address
Leaving Message*
 
Verification code
Submit

RS422 to TTL/UART/MCU Serial Port Signal Mutual Module with Over-Voltage Over-Current Protection-3.3V

VCC: + 3.3V TXD : The module's TTL (UART) to send, connected to the microcontroller's RXD receiver pin; RXD : The module's TTL (UART) receiver, connected to the microcontroller TXD send pin; GND : The module ground wire (this wire must be connected with the ground wire of microcontroller system);

Smart Electronics TTGO T-Display ESP32 WiFi And Ble Module Development Board

TTGO T-Display ESP32 WiFi And Ble Module Development Board Chipset： ESPRESSIF-ESP32 240MHz Xtensa® single-/dual-core 32-bit LX6 microprocessor FLASH： QSPI flash 4MB SRAM： 520 kB SRAM Button： Reset USB to TTL： CP2104 Modular interface： UART,SPI,SDIO,I2C,LED PWM,TV PWM,I2S,IRGPIO,ADC,capacitor touch sensor,DACLNA pre-amplifier

Smart Electronics MAX485 Module RS-485 TTL to RS485 MAX485CSA Converter Module

MAX485 Module RS-485 TTL to RS485 MAX485CSA Converter Module 1 on-board MAX485 chip , is a tool for RS-485 communications , low-power , Slew-Rate Transceiver 2 onboard then 5.08 (mm) pitch 2P terminal for easy wiring RS-485 communication 3 the chip has drawn all of the pins can be controlled by the microcontroller operation 4 Working voltage : 5V 5 board size : 44 (mm) x14 (mm)

Smart Electronics 0.49 inch OLED LCD screen 64*32 dot matrix SSD1306 driver 14Pin IIC interface

0.49 inch OLED LCD screen 64*32 dot matrix SSD1306 driver 14Pin IIC interface Feature Size: 0.49 inch Dot matrix: 64*32 Monochrome: white, blue Hardware interface: I2C (14 feet) Driver chip: SSD1306/SH1106 Drive voltage: 3.3V Working temperature: -40℃-+70℃; Storage temperature: -40℃-+85℃; Product features: self-luminous, high brightness, high contrast, ultra-thin, full viewing angle, visible under sunlight, wide temperature, low power consumption, fast response speed

Smart Electronics BLE 4.0 serial port patch type cc2540 cc2541 data transparent transmission iBeacon module

BLE 4.0 serial port patch type cc2540 cc2541 data transparent transmission iBeacon module ☆Ultra-low standby power consumption 90uA~400uA ☆ Ultra-long connection distance 100 feet/60 meters ☆Super fast response speed 0.4 seconds ☆ Android, Apple, PC, MAC are all universal. ☆No byte limit for sending and receiving, up to 3K Bytes/sec ☆ No need to do MFI ☆ IOS system is perfectly supported. ☆Android 4.3 system is perfectly supported.

Smart Electronics TTP223 touch button module self-locking inching capacitor switch single circuit reconstruction

TTP223 touch button module self-locking inching capacitor switch single circuit reconstruction Size:15mmX11MM Supply:2.5v-5.5v

Smart Electronics Wireless Charger 10W 7.5W PCBA Circuit Board Coil Module DIY Charger

Wireless Charger 10W 7.5W PCBA Circuit Board Coil Module DIY Charger The input voltage: 5V2A output : 5V1A The input voltage: 5V4A 9V1.67A(qc3.0) Output : 5V2A 9V1A Charging current: 1000mAh Charging power: up to 10W Wireless conversion efficiency: 73%, boost circuit 90%

Smart Electronics ESP32 WIFI BLE Single/Dual 4/8 channel Relay Module ESP32 Secondary Development Board

ESP32 WIFI BLE Single/Dual 4/8 channel Relay Module ESP32 Secondary Development Board

Smart Electronics Long Range Rfid 134.2 KHZ Reader module RDM660 Writer Transceivers

Long Range Rfid 134.2 KHZ Reader module RDM660 Writer Transceivers

Smart Electronics XH-M131 5V 12V 24V Light Control Switch Photoresistor Relay Module Detection Sensor 10A brightness Automatic Control Module

XH-M131 5V 12V 24V Light Control Switch Photoresistor Relay Module Detection Sensor 10A brightness Automatic Control Module

Smart Electronics PIR IR Light Motion Sensor Infrared Human Induction Lamp Switch 220V 50HZ Lights Control Ceiling On Off 3-6m Sensing

PIR IR Light Motion Sensor Infrared Human Induction Lamp Switch 220V 50HZ Lights Control Ceiling On Off 3-6m Sensing Product Parameter: 1.Sensing Mode:PIR sensing + light control 2.Rated Voltage:220V 50HZ 3.Output Way:Controllable Silicon 4.Load Power:filament lamp ≤100W electricity saving lamp ≤30W LED≤18W 5.Delay:20s (people are moving within the sensing range, the switch will auto delay ​and keep connecting;if people stay still,switch will stop responsing) 6.Sensing Distance:3-6m (high temperature will influence switch sensibility) 7.Sensing Angle:110° 8.Sensitivity to light :darkeness

Smart Electronics Golden SW-520D Angle Sensor Module Ball Switch Vibration Switch Tilt Sensor Module

Module features: 1. Using high sensitivity angle switch SW-520D as the sensor 2. Comparator output, clean signal, good waveform, strong driving ability, exceeding 15mA. 3. Working voltage 3.3V-5V 4. Output form: Digital switch output (0 and 1) 5. Equipped with fixed bolt holes for easy installation 6. Small PCB size: 3.2cm x 1.4cm 7. Using a wide voltage LM393 comparator

Smart Electronics GY-291 ADXL345 Digital Three 3 Triple Axis Sensor Acceleration Module IIC SPI Replace ADXL335

GY-291 ADXL345 Digital Three 3 Triple Axis Sensor Acceleration Module IIC SPI Replace ADXL335 1. Adxl345 digital three-axis acceleration of gravity tilt module Ar code iic / spi. 2. Name: the adxl345 module (three-axis acceleration of gravity). 3. use the chip: the adxl345. 4. power supply :3-5v. 5. means of communication: the iic / spi communication protocol. 6. measuring range: ± 2g ± 16g. 7. schematics, manuals and reference documentation of relevant data. 8. 51, the avr, the Ar microcontroller test code. 9. 3-axis, ± 2g / ± 4g / ± 8g / ± 16g.

Smart Electronics 43A current limiting control semiconductor refrigeration driven high-power intelligent vehicle motor drive module BTS7960

43A current limiting control semiconductor refrigeration driven high-power intelligent vehicle motor drive module BTS7960

Smart Electronics 4S 40A Li-ion Lithium Battery 18650 Charger PCB BMS Protection Board For 14.8V 16.8V Lipo Cell Module

4S 40A Li-ion Lithium Battery 18650 Charger PCB BMS Protection Board For 14.8V 16.8V Lipo Cell Module 4 string 16.8V 40A lithium battery protection board (comes with recovery function-AUTO Recovery) Scope: Nominal voltage of 3.6V, 3.7V lithium battery (including 18650,26650, polymer lithium battery) Product Size: 45 * 55 * 3.4mm (Standard Edition / Enhanced), 46 * 60 * 3.4mm (balanced version) Product weight: 9.3g (standard / enhanced version), 10.3g (balanced version) Charging voltage: 16.8V - 18.1V

Smart Electronics 1S 3A/5-6A BMS PCB Protection Board For 3.7V 18650 Li-Ion Lithium Battery

1S 3A/5-6A BMS PCB Protection Board For 3.7V 18650 Li-Ion Lithium Battery

Smart Electronics HC-42 Ble module BLE5.0 master-slave integration nRF52832 wireless serial communication ibeacon

HC-42 Ble module BLE5.0 master-slave integration nRF52832 wireless serial communication ibeacon Module Name: HC-42 Working frequency band: 24G Communication interface: UART Shutdown current: 0.3uA Communication level: 1.8-3.6V Transmission power: -40-4dBm Communication distance: 40m/2Mbps (Bluetooth 5.0) Antenna interface: built-in PCB antenna Receiving sensitivity: -96dbm@1Mbps Air speed: 1mbps/2mbps Working humidity: 10% -90% Storage temperature: -40 ° C~85 ° C Working temperature: -25 ° C -75 ° C

Smart Electronics DIY kit 3 Channel 2 * 18W 30W High Power Fever Super Bass AC TDA2030A Dual 12V Power Amplifier Board 2.1

DIY kit 3 Channel 2 * 18W 30W High Power Fever Super Bass AC TDA2030A Dual 12V Power Amplifier Board 2.1
Previous： Smart Electronics 37 in one sensor kit, 37 sensor kits, 45 in one sensor kit
Next： Smart Electronics IR Infrared Proximity Sensor Obstacle Avoidance module for Arduino Raspberry Pi DIY Smart Car 3PIN Robot Reflective Photoelec
Return
TOP
86-755-83877216
smartbes
smartbes