Search

Smart Electronics High-Precision Low-ower INMP441 Omnidirectional Microphone Module I2S Interface Supports ESP32

Products > Other Module > Smart Electronics High-Precision Low-ower INMP441 Omnidirectional Microphone Module I2S Interface Supports ESP32
    • 1
    • 2
    • 3
    • 4

Smart Electronics High-Precision Low-ower INMP441 Omnidirectional Microphone Module I2S Interface Supports ESP32

High-Precision Low-ower INMP441 Omnidirectional Microphone Module I2S Interface Supports ESP32
shared：

INMP441 omnidirectional microphone module MEMS high-precision 
low-power I2S interface supports ESP32

Product characteristics:

INMP441 is a high-performance, low-power, digital output, omnidirectional MEMS
microphone with bottom port.
1. Digit I with high-precision 24 bit data I² S interface
2. High signal-to-noise ratio of 61 dBA
3. High sensitivity -26 dBFS
4. Stable frequency response from 60 Hz to 15 kHz
5. Low power consumption: Low current consumption 1.4 mA
6. High PSR: -75 dBFS
Interface Definition:SCK: I ² Serial data clock of S interface WS: For I ² Serial Data Word Selection for S Interface L/R: Left/right channel selection. Set to low battery level, microphone at I ² Left channel output signal of frame S. Set to high level, microphone outputs signal on the right channel SD: I ² Serial data output of the S interface. VCC: Input power supply, 1.8V to 3.3V

GND: power ground


Name
Phone
Email
Corporate name
Address
Leaving Message*
 
Verification code
Submit

Smart Electronics JDY-16 Ble 4.2 module high-speed transparent BLE support airsync iBeacon super CC2541

JDY-16 Ble 4.2 module high-speed transparent BLE support airsync iBeacon super CC2541 Feature No byte limit for serial port transmission and reception during transparent transmission Effective communication distance within 80 meters Working temperature: -40~+80 ℃ Communication rate 8k Bytes per second Support UART and IIC communication methods Working voltage: 1.8-3.3V

Smart Electronics Dual coil fast wireless charger transmitter module PCBA board + 2 coil general qi standard diy board

Dual coil fast wireless charger transmitter module PCBA board + 2 coil general qi standard diy board Product Parameters 1. Input power supply: 5V 2A or 9V 1.67-2a, output: 5V 1A or 9V 1.2A 2. Product weight: 0.035kg 3. Charging power: 5W / 7.5w/10w automatic identification 4. Transmission distance: 2-8mm 5. Executive standard: Qi wireless charging standard 6. Product certification: CE / FCC / RoHS

Smart Electronics 24-hour timed 5 time periods real time relay module clock control/delay and clock synchronization module

24-hour timed 5 time periods real time relay module clock control/delay and clock synchronization module

Smart Electronics IPS 0.96-inch TFT display IPS LCD screen 0.96 "st7735 IPS display screen 0.96 inch LCD Module

IPS 0.96-inch TFT display IPS LCD screen 0.96 "st7735 IPS display screen 0.96 inch LCD Module

Smart Electronics QC2.0 QC3.0 Quick Charging USB Mobile Phone Charging Board DC Step-down Module

QC2.0 QC3.0 Quick Charging USB Mobile Phone Charging Board DC Step-down Module

Smart Electronics 3.5-inch TFT LCD display screen module serial port SPI driver ILI9488 with capacitive touch RGB 320 * 480

3.5-inch TFT LCD display screen module serial port SPI driver ILI9488 with capacitive touch RGB320 * 480

TPA3118 Mono Digital Amplifier Module Board High Sound Quality 60W

Smart Electronics JDY08 Ble 4.0 BLE low-power CC2541 master-slave integrated airsync iBeacon Ble module

JDY08 Ble 4.0 BLE low-power CC2541 master-slave integrated airsync iBeacon Ble module Feature The JDY-08 transparent transmission module is based on the Bluetooth 4.0 protocol standard, with a working frequency range of 2.4GHz and a modulation method of GFSK. The maximum transmission power is 0dB and the maximum transmission distance is 80 meters. It adopts the TCC2541 chip design and supports users to modify device names, service UUID, transmission power, pairing passwords and other instructions through AT commands, making it convenient, fast, and flexible to use.

Smart Electronics 5M-6GHz Gain 20dB hf ultra breitband amplifier 6g ultra wideband medium power RF amplifier with Shielded Case

5M-6GHz Gain 20dB hf ultra breitband amplifier 6g ultra wideband medium power RF amplifier with Shielded Case

Smart Electronics Sound sensor module voice control switch strength detection audio amplifier microphone LM386

Sound sensor module voice control switch strength detection audio amplifier microphone LM386 The LM386 is an audio integrated power amplifier with its own low power consumption, adjustable gain for updating the internal chain, wide supply voltage range, fewer external components and less total harmonic distortion. It is mainly used in low-voltage consumer products. In order to minimize the peripheral components, the voltage gain is built-in as 20, and by adding an external resistor and capacitor between pin 1 and pin 8, the voltage gain can be adjusted to any value within 200.

Smart Electronics TTP223 TTP223B Jog digital touch sensor capacitive touch touch switch modules Accessories

TTP223 TTP223B Jog digital touch sensor capacitive touch touch switch modules Accessories The module is a capacitive touch switch module based on touch detection IC (ttp223b). Under normal condition,the module outputs low level and the mode is low power consumption mode; when touching the corresponding position with fingers, the module outputs high level and the mode switches to fast mode; when there is no touch for 12 seconds, the mode switches to low power consumption mode.

Smart Electronics New Arrival Raspberry Pi 3 Model B+ Wide Angle Camera 5MP Adjustable-focus Mini Vision Video Camera module

New Arrival Raspberry Pi 3 Model B+ Wide Angle Camera 5MP Adjustable-focus Mini Vision Video Camera module Temperature (Operation): -20°C to 70°C Temperature (Stable Image) : 0°C to 50°C Focus :Fixed Object distance:30CM-∞ Resolution: 800LW/PH (Center) Working power supply : 3.3v(pin15) Operating system: for Raspberry Pi Certifications :FCC and CE Sensor Type: OV5647 (1/4” ) Active Array Size : 2592*1944 Sensitivity: 600mV/Lux-sec F/No: 2.35 EFL: 1.55 mm BFL(Optical): 3.1mm FOV: 160° TV Distortion :<14.5% Relative Illumination (Sensor) : 70% IR Filter : 650±10nm

Smart Electronics MT3608 dc to dc step up booster module 28V 2A Adjustable Boost Converter Module

MT3608 dc to dc step up booster module 28V 2A Adjustable Boost Converter Module

Smart Electronics HC-SR505 Mini sensor di movimento a infrarossi PIR sensor preciso a infrarossi SR505

HC-SR505 Mini sensor di movimento a infrarossi PIR sensor preciso a infrarossi SR505

SIM900A module, development board, GSM/GPRS/STM32 \ super TC35i wireless data transmission module

Product Description: ardu 51 STM32 AVR MCU compatible Prototype expand The dual frequency 900/ 1800 MHz, GPRS multi-slot class 10/8,GPRS mobile station class B Power supply range: voltage is 4.6-5.2v; current is 1A or more(the current is very important). Low power consume: 1.5mA (sleep mode) Operating temperature range: -40 degrees C to +85 C Communication interface: The TTL level serial interface compatible 2.85 3.3 5v MCU Size:49*50mm

Smart Electronics Stabilized voltage power board 3A LM2576 12V24V to 5V3.3V LM2596S adjustable dc dc step-down module

Stabilized voltage power board 3A LM2576 12V24V to 5V3.3V LM2596S adjustable dc dc step-down module

Smart Electronics HC-42 Ble module BLE5.0 master-slave integration nRF52832 wireless serial communication ibeacon

HC-42 Ble module BLE5.0 master-slave integration nRF52832 wireless serial communication ibeacon Module Name: HC-42 Working frequency band: 24G Communication interface: UART Shutdown current: 0.3uA Communication level: 1.8-3.6V Transmission power: -40-4dBm Communication distance: 40m/2Mbps (Bluetooth 5.0) Antenna interface: built-in PCB antenna Receiving sensitivity: -96dbm@1Mbps Air speed: 1mbps/2mbps Working humidity: 10% -90% Storage temperature: -40 ° C~85 ° C Working temperature: -25 ° C -75 ° C

Smart Electronics Golden SW-520D Angle Sensor Module Ball Switch Vibration Switch Tilt Sensor Module

Module features: 1. Using high sensitivity angle switch SW-520D as the sensor 2. Comparator output, clean signal, good waveform, strong driving ability, exceeding 15mA. 3. Working voltage 3.3V-5V 4. Output form: Digital switch output (0 and 1) 5. Equipped with fixed bolt holes for easy installation 6. Small PCB size: 3.2cm x 1.4cm 7. Using a wide voltage LM393 comparator

Smart Electronics 4 channel 5V 12V 24V relay module with optocoupler low level trigger development board module

4 channel 5V 12V 24V relay module with optocoupler low level trigger development board module 5 V-12V to TTL control signal The control signal DC or AC, 220V AC load can be controlled. There is a normally open and one normally closed contact A power indicator light A control indicator, pull off, disconnect does not shine Transistor drive to increase the relay coil control pins high impedance. The control pin has a pull-down circuit to prevent malfunction relay vacant.
Previous： Other Electric Components Sourcing Electronic Components Accessories PCBA Assemblies Manufacturing Service SMT DIP
Next： Smart Electronics Digispark Kickstarter Micro USB Development Board For ATTINY85 Ardu
Return
TOP
86-755-83877216
smartbes
smartbes