Search

TPA3110 XH-A232 30W+30W 2.0 Channel Digital Stereo Audio Power Amplifier DC 8-26V 3A C6-001 3110 Amplifier Board

Products > Module > TPA3110 XH-A232 30W+30W 2.0 Channel Digital Stereo Audio Power Amplifier DC 8-26V 3A C6-001 3110 Amplifier Board
    • 1
    • 2
    • 3
    • 4
    • 5

TPA3110 XH-A232 30W+30W 2.0 Channel Digital Stereo Audio Power Amplifier DC 8-26V 3A C6-001 3110 Amplifier Board

shared：
TPA3110 XH-A232 30W+30W 2.0 Channel Digital Stereo Audio Power Amplifier Board DC 8-26V 3A
Product description:
Parameter:
Chip: TPA3110
Condition:XH-A232
Application:Computer
Supply Voltage:DC8V-26V
Dissipation Power:30W+30W
Size:53*45*14mm
Channels:2 (2.0)
Output impedance:4-8ohm
Current: more than 3A
Signal to noise ratio: 100db
Weight:21g


Name
Phone
Email
Corporate name
Address
Leaving Message*
 
Verification code
Submit

Smart Electronics Relay Module For ARM PIC AVR DSP 10A 5V 2 Channel Relay Module Shield

Relay Module For ARM PIC AVR DSP 10A 5V 2 Channel Relay Module Shield Specifications : Size: 3.9cm x 5.1cm Materials: PCB board and electronic components Package included : 1 x 5V 2-Channel Relay Module Shield

Smart Electronics BLE 4.0 serial port patch type cc2540 cc2541 data transparent transmission iBeacon module

BLE 4.0 serial port patch type cc2540 cc2541 data transparent transmission iBeacon module ☆Ultra-low standby power consumption 90uA~400uA ☆ Ultra-long connection distance 100 feet/60 meters ☆Super fast response speed 0.4 seconds ☆ Android, Apple, PC, MAC are all universal. ☆No byte limit for sending and receiving, up to 3K Bytes/sec ☆ No need to do MFI ☆ IOS system is perfectly supported. ☆Android 4.3 system is perfectly supported.

Smart Electronics XH-M203 Full Automatic Water Level Controller Pump Switch Module AC/DC 12V Relay

XH-M203 Full Automatic Water Level Controller Pump Switch Module AC/DC 12V Relay

Smart Electronics IR Infrared Proximity Sensor Obstacle Avoidance module for Arduino Raspberry Pi DIY Smart Car 3PIN Robot Reflective Photoelec

IR Infrared Proximity Sensor Obstacle Avoidance module for Arduino Raspberry Pi DIY Smart Car 3PIN Robot Reflective Photoelec

3.5 inch SPI serial port TFT LCD display module LCD touch screen ILI9488/6/1 driver 320X480

DC-DC XL7015 module 5V-80V 0.8A Dc converter Step-down module Wide voltage input better than XL7005A

Long Range Rfid 134.2 KHZ Reader module RDM660 Writer Transceivers

DIY Ble 5.0 Audio Receiver Module MP3 Ble Decoder Board Car Audio Speaker 4.1

1000W ZVS Carbon Steel Flyback Driver Low Voltage Stable Induction Heating Board Module Plate

100% brand new and high quality! This section of induction heating using low-voltage DC power supply 12-48V. Maximum current 20A, maximum power 1000W. Can be used for DIY players to heat treatment of small parts such as quenching, annealing, etc. Can directly heat iron, carbon steel, graphite, titanium alloy and other materials. Also can be used with a graphite crucible melting gold, silver, copper, aluminum and other metals, uniform heating fast, very convenient.

Smart Electronics Touch Button Module Capacitor Switch Sensor TTP223

LCD1602 yellow-green screen 1602A lcd display blue

69.5*21.8*17.8 weighs about 30 grams

MAX7219 led dot matrix module 4 in 1 display module single chip microcomputer control drive module with 5p wire

MAX7219 is an integrated serial input/output common-cathode display driver, which connects a microprocessor and an 8-digit 7-segment digital LED display, and can also be connected to a bar graph display or 64 independent LEDs. It includes an on-chip B-type BCD encoder, multiple scan loops, segment word drivers, and an 8*8 static RAM to store each data. Only one external register is used to set the segment current of each LED.

Smart Electronics JDY-23 BLE5.0 ble transparent data transmission CC2541 slave bluetooth module

JDY-23 BLE5.0 ble transparent data transmission CC2541 slave bluetooth module Model: JDY-23 Working frequency band: 2.4G Transmission power: 4dB (maximum) Communication interface: UART Working voltage: 1.8-3.6V Working temperature: -40 ℃ -80 ℃ Antenna: Built in PCB antenna Receiving sensitivity: -97dbm Transmission distance: 60 meters Master Slave Support: Slave Module size: 19.6 * 14.94 * 18mm (length, width, height) Bluetooth version: BLE5.0 (also includes BLE4.0 and BLE4.2) Wake up current: 800uA (with broadcast) Shallow sleep current:<50uA (with broadcast) Command parameters: Save parameter configuration, power-off data saved SMT welding temperature:<260 ℃ RF TX/RX peak current: 5mA

TTP223 TTP223B Jog digital touch sensor capacitive touch touch switch modules Accessories

The module is a capacitive touch switch module based on touch detection IC (ttp223b). Under normal condition,the module outputs low level and the mode is low power consumption mode; when touching the corresponding position with fingers, the module outputs high level and the mode switches to fast mode; when there is no touch for 12 seconds, the mode switches to low power consumption mode.

Smart Electronics ESP32 WIFI BLE Single/Dual 4/8 channel Relay Module ESP32 Secondary Development Board

ESP32 WIFI BLE Single/Dual 4/8 channel Relay Module ESP32 Secondary Development Board

Smart Electronics 5M-6GHz Gain 20dB hf ultra breitband amplifier 6g ultra wideband medium power RF amplifier with Shielded Case

5M-6GHz Gain 20dB hf ultra breitband amplifier 6g ultra wideband medium power RF amplifier with Shielded Case

Smart Electronics CO2 Carbon Dioxide Sensor Module MG811 Voltage 0-2V Voltage output Original stock

CO2 Carbon Dioxide Sensor Module MG811 Voltage 0-2V Voltage output Original stock

XL 6009 DC to DC Step Up Converter xl6009 step-up power module dc motor

This DC-DC Module is based on IC XL6009E1 which is a high-performance step-up switching current (BOOST) module. The module uses the second generation of high-frequency switching technology XL6009E1 core chip that offers superior performance over the first generation technology LM2577. XL6009 replaces LM2577 module as LM2577 is about to be phased out.

MAX31865 temperature sensor detector module temperature acquisition RTD/PT100-PT1000

●Support 100Ω to 1kΩ (at 0°C) platinum resistance RTD (PT100 to PT1000) ●Conversion time: 21ms (maximum) ●15-bit ADC resolution; nominal temperature resolution is 0.03125°C (non-linear change with RTD) ● Under the whole working conditions, the total accuracy is maintained at 0.5°C (0.05% full range) ● SPI compatible interface, compatible with 2-wire, 3-wire and 4-wire sensor connection

Smart Electronics HC-08 BLE4.0 master-slave integrated Bluetooth module CC2540 wireless serial communication data transmission module

HC-08 BLE4.0 master-slave integrated Bluetooth module CC2540 wireless serial communication data transmission module Product model: HC-08 Working frequency band: 2.4G Communication interface: UART3.3VTL level Working voltage: 3.0-3.6V RSSI support: not supported Communication level: 3.3V Transmission power: 4dBm Reference distance: 80 meters Air speed: 2Mbps Antenna interface: built-in PCB antenna Communication current: 0.4uA Receiving sensitivity: 85dbm@2Mbps Working humidity: 10%~90% Storage temperature: 40 ℃ -+80 ℃ Working temperature: -25 ℃ -75 ℃
Previous： CH341A+SOP8 test clamp+1.8V conversion socket+SOP8 to DIP8 PROGRAMMER socket 5 pieces set
Next： Smart Electronics Electric vehicle motor Hall two wheeled vehicle motor board 120 degrees hall sensors for brushless motor
Return
TOP
86-755-83877216
smartbes
smartbes