Search

Smart Electronics 3.5A DC12V/24V PWM Motor Speed Regulator LED Dimmer Suitable for Brushed and Brushless Motors

Products > Module > Smart Electronics 3.5A DC12V/24V PWM Motor Speed Regulator LED Dimmer Suitable for Brushed and Brushless Motors
    • 1

Smart Electronics 3.5A DC12V/24V PWM Motor Speed Regulator LED Dimmer Suitable for Brushed and Brushless Motors

3.5A DC12V/24V PWM Motor Speed Regulator LED Dimmer Suitable for Brushed and Brushless Motors
shared：

Smart Electronics 3.5A DC12V/24V PWM Motor Speed Regulator LED Dimmer Suitable for Brushed 

and Brushless Motors

Basic Specifications

Input Voltage: DC 12V / 24V (Current varies by voltage)

Output Current:

DC12V: Maximum continuous current 3.5A

DC24V: Maximum continuous current 1.5A (Power-limited)

Suitable Loads: DC devices such as brushed motors, brushless motors, LED strips/fixtures, fans, water pumps, etc.

Functions & Features

Control Method: PWM (Pulse Width Modulation) – Adjusts duty cycle via knob for stepless speed/brightness control

Adjustment Range: 0%–100% (corresponding to speed/brightness from 0 to maximum)

Protection Features: Built-in overheat protection, short-circuit protection (Some models include self-resetting fuses)

Size & Mounting: Compact PCB board design with screw terminals (for easy wiring) and mounting holes

Important Notes

Supports DC input only; do not connect to 220V AC power;

Ensure voltage and current compatibility (e.g., load current must not exceed 1.5A at 24V);

The controller includes a heat sink; avoid prolonged full-load operation.


Name
Phone
Email
Corporate name
Address
Leaving Message*
 
Verification code
Submit

Smart Electronics Sound sensor module voice control switch strength detection audio amplifier microphone LM386

Sound sensor module voice control switch strength detection audio amplifier microphone LM386 The LM386 is an audio integrated power amplifier with its own low power consumption, adjustable gain for updating the internal chain, wide supply voltage range, fewer external components and less total harmonic distortion. It is mainly used in low-voltage consumer products. In order to minimize the peripheral components, the voltage gain is built-in as 20, and by adding an external resistor and capacitor between pin 1 and pin 8, the voltage gain can be adjusted to any value within 200.

Smart Electronics DC-DC Step Up Converter Booster Power Supply Module Boost Step-up Board MAX output 28V 2A MT3608

DC-DC Step Up Converter Booster Power Supply Module Boost Step-up Board MAX output 28V 2A MT3608

Smart Electronics Flame Sensor Module & Infrared Receiving Module (3-wire System) ,Blue Board

Flame Sensor Module & Infrared Receiving Module (3-wire System) ,Blue Board The flame sensor is sensitive to flame and is also reactive to ordinary light. It is generally used for flame alarms and other purposes. the small board output interface can be directly connected to the IO port of the microcontroller small board analog output mode and AD conversion processing, can achieve higher precision

Smart Electronics HUB USB expansion board USB HUBS splitter expansion module suitable for Raspberry Pi 4B/3B+/3A+/3B/2B/B+/A+/zero/w

HUB USB expansion board USB HUBS splitter expansion module suitable for Raspberry Pi 4B/3B+/3A+/3B/2B/B+/A+/zero/w Features: 4 USB expansion ports, compatible with USB2.0 / 1.1 transmission USB to UART for Raspberry Pi for serial debugging Multiple indicators for easy access to power, USB to UART and USB expansion interface Operating voltage: 5V Product Size: 65mm × 30mm Fixed hole diameter: 3.0mm Not include Raspberry Pi

Smart Electronics W1209 LED Digital Thermostat Temperature Control Thermometer Thermo Controller Switch Module DC 12V Waterproof NTC Sensor

W1209 LED Digital Thermostat Temperature Control Thermometer Thermo Controller Switch Module DC 12V Waterproof NTC Sensor Temperature range :-50-110 ° Dimensions: 48.5 * 40mm Temperature control mode: ON / OFF Resolution:When temperature is 0.1°, the resolution is -9.9~99.9, other temperature segment is 1° Control accuracy: 0.1 ° Hysteresis accuracy: 0.1° Refresh rate: 0.5S High temperature protection: 0-110° Supply voltage: DC 12V Static current: ≤ 35MA, attract current ≤ 65MA Output voltage: DC 12V Output power: 20A relay

Smart Electronics LNA 50-4000 MHz RF SPF5189 NF 0.6dB Low Noise Amplifier Signal Receiver Board Wireless Communication Module With Shield Shell

LNA 50-4000 MHz RF SPF5189 NF 0.6dB Low Noise Amplifier Signal Receiver Board Wireless Communication Module With Shield Shell Specifications: LNA: 50-4000mhz NF: SPF5189Z LNA0: 0.6 dB Amplifier: FM Size: 34 x 25mm/1.33 x1.0inch

Smart Electronics IC Brand new original MH-Z14 carbon dioxide sensor module CO2 detection air quality detection module for agricultural greenhouse

IC Brand new original MH-Z14 carbon dioxide sensor module CO2 detection air quality detection module for agricultural greenhouse

Smart Electronics GSM module, SIM808 Module with GPS antenna GSM GPRS GPS development board

GSM module, SIM808 Module with GPS antenna GSM GPRS GPS development board This module is 5-12V power supply, when the power supply is less than 9V, 2A DC is required. The other power supply port is 3.5-4.2V, suitable for lithium battery power supply. The computer can debug USB-TTL. Suitable for portable. Two sets of antenna SMA ports, GPS and GSM antennas are provided.

Smart Electronics KY-013 3PIN Analog Temperature Sensor Module KY-013

KY-013 3PIN Analog temperature sensor module KY-013

Smart Electronics DIY kit 3 Channel 2 * 18W 30W High Power Fever Super Bass AC TDA2030A Dual 12V Power Amplifier Board 2.1

DIY kit 3 Channel 2 * 18W 30W High Power Fever Super Bass AC TDA2030A Dual 12V Power Amplifier Board 2.1

Smart Electronics TTL Turn RS485 Module 485 to Serial UART Level Mutual Conversion Hardware Automatic Flow Control Module

TTL Turn RS485 Module 485 to Serial UART Level Mutual Conversion Hardware Automatic Flow Control Module Product parameters: Operating voltage: compatible with 3.3V and 5.0V Support baud rate: 110-256000bps Operating temperature: -40 Celsius to +85 Celsius Communication signal: compatible with 3.3V and 5.0V

Smart Electronics LORA RFM95 RFM95W 868 915 RFM95-868MHz RFM95-915MHz SX1276 wireless transceiver module

LORA RFM95 RFM95W 868 915 RFM95-868MHz RFM95-915MHz SX1276 wireless transceiver module The RFM95 transceiver is a LoRaTM remote communication module, which provides ultra long distance spread spectrum communication and has super strong anti-interference capability and ultra low current consumption.

Smart Electronics HX711 Dual-Channel 24-bit A/D Conversion Load Cell Module With Metal Barrier

HX711 Dual-Channel 24-bit A/D Conversion Load Cell Module With Metal Barrier

Smart Electronics 0.49 inch 0.5 inch OLED 64x32 ssd1315 0.49 OLED display screen highlighted OLED

0.49 inch 0.5 inch OLED 64x32 ssd1315 0.49 OLED display screen highlighted OLED

Smart Electronics TDA7293/TDA7294 Mono Channel Amplifier Module Circuit PCB Bare Board 4XFB

TDA7293/TDA7294 Mono Channel Amplifier Module Circuit PCB Bare Board 4XFB Model: TDA7293/TDA7294 Power supply: double AC 15V to 36V (AC needs rectification and filtering) or DC positive and negative 18V to 50V.Recommended double 35V (Note that it is not a dual 35V transformer, it is positive and negative 35V DC. And It is recommended to double 26V/200W toroidal transformer, after rectification voltage is about DC double 35V).

Smart Electronics DC 12V-24V TPA3118 60W Mono Digital Audio Power Amplifier Board Amp Module

DC 12V-24V TPA3118 60W Mono Digital Audio Power Amplifier Board Amp Module product description: Power amplifier chip: TPA3118 Amplifier power: 1*60W Supply voltage: 8~24VDC Speaker impedance: 4-8Ω Size: 46*35*1.6mm (length, width and thickness) Total height of the board: 12mm

Smart Electronics ESP32 WIFI BLE Single/Dual 4/8 channel Relay Module ESP32 Secondary Development Board

ESP32 WIFI BLE Single/Dual 4/8 channel Relay Module ESP32 Secondary Development Board

Smart Electronics CH341 24 25 Series EEPROM Flash BIOS USB Programmer with Software & Driver

CH341 24 25 Series EEPROM Flash BIOS USB Programmer with Software & Driver

Smart Electronics JDY-08 blue tooth 4.0BLE low-power CC2541 master-slave integrated support airsync iBeacon module

JDY-08 blue tooth 4.0 BLE low-power CC2541 master-slave integrated support airsync iBeacon module
Previous： Smart Electronics PWM DC motor speed regulator 5V-16V12V speed control switch LED dimming speed control module 10A with switch
Next： Smart Electronics PWM DC motor speed regulator with high power DC12V-40V and gear board motor speed regulation module 10A
Return
TOP
86-755-83877216
smartbes
smartbes