Search

Smart Electronics Duct type temperature and humidity sensor housing

Products > Sensor > Smart Electronics Duct type temperature and humidity sensor housing
    • 1
    • 2
    • 3
    • 4

Smart Electronics Duct type temperature and humidity sensor housing

Duct type temperature and humidity sensor housing

1. Copper sintered dust cover
2. Stainless steel lock wire seat
3. Good air permeability
4. Widely applicable
5. High cost performance
shared：


Feature

1. Copper sintered dust cover

2. Stainless steel lock wire seat

3. Good air permeability

4. Widely applicable

5. High cost performance



Name
Phone
Email
Corporate name
Address
Leaving Message*
 
Verification code
Submit

Thin Film Pressure Sensor DF9-40 High Precise Force Sensing Resistor Resistance-type Flexible Pressure Sensor

This flexible pressure sensor is based on new nanometer pressure-sensitive materials supplemented by ultra-thin film substrate. Highly sensitive flexible nanometer materials can realize highly sensitive detection of pressure. It has pressure sensitive function as well as water-resistant function. When sensor detects outside pressure, the resistance of sensor will change. Pressure signal can be converted into a corresponding electrical signal output using simple circuit.

Smart Electronics TGS822 TGS 822 alcohol gas sensor

TGS822 TGS 822 alcohol gas sensor Parameters: Alcohol measurement range: 50-5,000ppm Sensitivity (resistance ratio): 0.40 ± 0.1 Circuit voltage: 24V (DC/AC) Heater voltage: 5V±0.2V(AC/DC)

Smart Electronics MQ-9 carbon monoxide Combustible gas sensor alarm module

MQ-9 carbon monoxide Combustible gas sensor alarm module Feature: Size: 32mm * 22mm * 27mm Main chip: LM393, MQ-9 gas sensors Working voltage: DC 5 V Characteristics: 1, having a signal output instruction. 2, dual signal output (analog output, and TTL level output) 3, TTL output valid signal is low. (Low-level signal when the output light can be directly connected to the microcontroller) 4, 0 - 5V analog output voltage, the higher the concentration the higher the voltage. 5, for CO, gas, liquefied petroleum gas with high sensitivity and good selectivity. 6, has a long life and reliable stability 7, rapid response and recovery characteristics Application: MQ-9 sensor main family, environmental detection of carbon monoxide gas for CO, gas, liquefied petroleum gas field testing;

M12 proximity switch sensor LJ12A3-4-Z/BX/BY/AX/AY/EX/DX/EZ/DZ normally open 24V

Current specification: 300mA Rated working voltage: DC: 6-36V Distance measurement: 4mm±10% Output mode: NPN NO (normally open) Level signal: low level Installation method: non-embedded Thread diameter: M12X1 Shell material: brass nickel plated Wire length: 1.2 meters

Smart Electronics E-bike Accessories Brushless Electric Motor Hall Sensor 3144 Circuit Board 41F 43F with Wire

E-bike Accessories Brushless Electric Motor Hall Sensor 3144 Circuit Board 41F 43F with Wire Product Categories (please choose the one you need) 1. Two-wheeled 13A 120 degrees 2. Two-wheeled 413 120 degrees 3. Two-wheeled 41F 120 degrees 4. Two-wheeled 43F 120 degrees 5. Two-wheeled 3144 120 degrees 6. Two-wheeled 13A 60 degrees 7. Two-wheeled 413 60 degrees 8. Two-wheeled 41F 60 degrees 9. Two-wheeled 43F 60 degrees 10.Two-wheeled 3144 60 degrees

DHT22 digital temperature and humidity sensor AM2302 temperature humidity module

Technical parameter Measuring range Temperature: -40….+80°℃ Humidity: 0...99.9%RH

AM2305 Digital temperature and humidity sensor

1) The relative humidity and temperature, calibration of all digital output 2) Excellent long-term stability 3) Without additional components 4) Long distance signal transmission 5) ultra low power 6) 4 pin installation 7) Completely interchangeable

Smart Electronics WSH135 W135 hall element TO92, SOT23 package sensor linearity 1.5 mV/G hall sensor

WSH135 W135 hall element TO92, SOT23 package sensor linearity 1.5 mV/G hall sensor

Thermistor Temperature Sensor Shell 5*25mm Nickel-plated Copper Shell PT100 Shell

4*11 4*20 5*20 5*22.5 5*25 6*30 4.2 annular hole M6 stainless steel thread M8 stainless steel thread M6 split nickel-plated copper shell 5*50Stainless steel shell annealed shell groove 6*50Stainless steel shell annealed shell groove

MAX31865 temperature sensor detector module temperature acquisition RTD/PT100-PT1000

●Support 100Ω to 1kΩ (at 0°C) platinum resistance RTD (PT100 to PT1000) ●Conversion time: 21ms (maximum) ●15-bit ADC resolution; nominal temperature resolution is 0.03125°C (non-linear change with RTD) ● Under the whole working conditions, the total accuracy is maintained at 0.5°C (0.05% full range) ● SPI compatible interface, compatible with 2-wire, 3-wire and 4-wire sensor connection

SHTC1 humidity and temperature sensor temperature sensor for agricultural

Datasheet SHTC1 Humidity and Temperature Sensor IC Best performance-to-price ratio Fully calibrated and reflow solderable Ultra-low power consumption Power-up and measurement within 1 ms 1.8 V supply voltage Ultra-small DFN package : 2 x 2 x0 . 75 mm³ Typical accuracy : ± 3% RH and + 0.3 ºC

Smart Electronics Stainless steel fixed thread temperature sensor Kt100 RTD / E-type thermocouple waterproof temperature measurement wire probe

Stainless steel fixed thread temperature sensor Kt100 RTD / E-type thermocouple waterproof temperature measurement wire probe

Force Sensor RP-C18.3-ST Flexible Thin Film Pressure Sensor Intelligent 20g-6kg

The flexible sensor has the characteristics of flexible ultra-thin, ultra-low power consumption and extreme speed response, etc. Small size, this flexible pressure sensor is based on new nanometer pressure-sensitive materials ​supplemented by ultra-thin film substrate. This pressure sensor has the characteristic of high stability, high consistency. Highly sensitive flexible nanometer materials can realize highly sensitive detection of pressure.

D2027 piezoresistive flexible film pressure sensor foot pressure force measurement customization

Terminal type Male terminal Female terminal Pressure range 500g 2kg 5kg 10kg 20kg 40kg 60kg 100kg

Smart Electronics Hall effect sensor ss49e 49e hall element oh49e

Hall effect sensor ss49e 49e hall element oh49e The 49E is a Hall-effect integrated circuit. The output voltage changes with the change of the magnetic flux density, and it can detect the slight change of the magnetic field. It can be used to measure the motion of objects, distance, position sensor, etc. It is alsosuitable for use in harsh environments or heavily polluted conditions.

Thin film pressure sensor resistive force sensitive and pressure sensitive plantar flexible PVDF robot tactile FSR402 406

SHT10 temperature and humidity sensor SHT11 SHT15 guarantee new original

SHT1x - Digital Temperature and Humidity Sensor (RH/T) SHT1x series SHT10 - low cost version, ±4.5% RH accuracy SHT11 - standard version, ±3% RH accuracy SHT15 - high-end version, ±2% RH accuracy

Smart Electronics TO-92 Temperature sensor 18B20 Sensor Electronic chip IC for sensor hall electronic components

TO-92 Temperature sensor 18B20 Sensor Electronic chip IC for sensor hall electronic components Condition:New Supply Voltage:standar Dissipation Power:standar Operating Temperature:standar Funtion:temperature sensor
Previous： Smart Electronics Stainless steel temperature sensor probes
Next： Smart Electronics NTC Probe for immersion sensor custom steel tube 50mm
Return
TOP
86-755-83877216
smartbes
smartbes