Search

FSR406 Pressure Sensor , 100% New and Original Force Sensitive Resistor

Products > Sensor > FSR406 Pressure Sensor , 100% New and Original Force Sensitive Resistor
    • 1
    • 2
    • 3

FSR406 Pressure Sensor , 100% New and Original Force Sensitive Resistor

This is a force sensitive resistor with a square, 1.75x1.5", sensing area. This FSR will vary its resistance depending on how much pressure is being applied to the sensing area. The harder the force, the lower the resistance. When no pressure is being applied to the FSR its resistance will be larger than 1MΩ. This FSR can sense applied force anywhere in the range of 100g-10kg.
shared：


Features:
This is a force sensitive resistor with a square, 1.75x1.5", sensing area. This FSR will vary its resistance depending on how
much pressure is being applied to the sensing area. The harder the force, the lower the resistance. When no pressure is
being applied to the FSR its resistance will be larger than 1MΩ. This FSR can sense applied force anywhere in the range
of 100g-10kg.

Two pins extend from the bottom of the sensor with 0.1" pitch making it bread board friendly. There is a peel-and-stick
rubber backing on the other side of the sensing area to mount the FSR.

These sensors are simple to set up and great for sensing pressure, but they aren't incredibly accurate. Use them to sense
if it's being squeezed, but you may not want to use it as a scale.

* Overall length: 3.5"
* Overall width: 1.75"
* Sensing area: 1.75x1.5"


Name
Phone
Email
Corporate name
Address
Leaving Message*
 
Verification code
Submit

Thin film pressure sensor, Square 16 nodes side length 20 mm flexible resistive motion sensor

The IMM0092 of Idong Film Electronics is a member of the single-node sensor family. Although IMM092 has 16 nodes, because IMM00092 has 32 lines of output, each node has 2 lines of output, and the 16 nodes are independent of each other. They are very reliable piezoresistive sensors. When the pressure (pressure) applied to the effective area of the sensor increases, the output resistance of the sensor decreases. Single-point sensors can be measured using a multimeter or customer's own circuit.

Thin Film Pressure Sensor DF9-40 High Precise Force Sensing Resistor Resistance-type Flexible Pressure Sensor

This flexible pressure sensor is based on new nanometer pressure-sensitive materials supplemented by ultra-thin film substrate. Highly sensitive flexible nanometer materials can realize highly sensitive detection of pressure. It has pressure sensitive function as well as water-resistant function. When sensor detects outside pressure, the resistance of sensor will change. Pressure signal can be converted into a corresponding electrical signal output using simple circuit.

AM2305 Digital temperature and humidity sensor

1) The relative humidity and temperature, calibration of all digital output 2) Excellent long-term stability 3) Without additional components 4) Long distance signal transmission 5) ultra low power 6) 4 pin installation 7) Completely interchangeable

PIR IR Light Motion Sensor Infrared Human Induction Lamp Switch 220V 50HZ Lights Control Ceiling On Off 3-6m Sensing

Product Parameter: 1.Sensing Mode:PIR sensing + light control 2.Rated Voltage:220V 50HZ 3.Output Way:Controllable Silicon 4.Load Power:filament lamp ≤100W electricity saving lamp ≤30W LED≤18W 5.Delay:20s (people are moving within the sensing range, the switch will auto delay ​and keep connecting;if people stay still,switch will stop responsing) 6.Sensing Distance:3-6m (high temperature will influence switch sensibility) 7.Sensing Angle:110° 8.Sensitivity to light :darkeness

Smart Electronics PT100 temperature sensor thermal resistance thermocouple WZP-035 probe waterproof and corrosion resistant high temperature

PT100 temperature sensor thermal resistance thermocouple WZP-035 probe waterproof and corrosion resistant high temperature Non-standard customization High temperature thermal resistance 450 degree specification price as above NTC thermal 4*30*2 meters K type PTFE low temperature 200 degrees 2*30mm*1m A grade three core

Industrial-grade MINI I2C interface High-precision Si7021 temperature and humidity sensor

Working voltage: 1.9-3.6V (3.3V recommended) Standby current: 60nA Temperature range: -40-85°C (recommended -10-60°C) Temperature accuracy: ±0.4℃ (-10-85℃) Humidity range: 0-RH (20%-80%RH recommended) Humidity accuracy: ±3%RH (0-80%RH) Temperature conversion time: 7ms Humidity conversion time: 17ms (temperature conversion will be performed automatically when humidity conversion is performed) Interface type: I2C 2.54mm pitch pad Module size: 8.5X10mm

Smart Electronics MQ-2 MQ-3 MQ-4 MQ-5 MQ-6 MQ-7 MQ-8 MQ-9 MQ-135 gas sensor probe non-module

MQ-2 MQ-3 MQ-4 MQ-5 MQ-6 MQ-7 MQ-8 MQ-9 MQ-135 gas sensor probe non-module Feature 1. Good sensitivity to combustible gas in a wide concentration range. 2. High sensitivity to methane 3. Long service life and low cost. 4. A simple drive circuit is enough. 5. Household gas leak alarm. 6. Industrial combustible gas alarm. 7. Portable gas detector.

Smart Electronics MQ-3 detects alcohol sensor, ethanol sensor, combustible gas sensor probe

MQ-3 detects alcohol sensor, ethanol sensor, combustible gas senso Feature Product model: MQ-3 Product Type: Semiconductor gas sensor Standard package: Bakelite (Black Bakelite) Detection gas: alcohol vapor Detection concentration: 0.04-4mg/L alcohol

Smart Electronics WSH135 W135 hall element TO92, SOT23 package sensor linearity 1.5 mV/G hall sensor

WSH135 W135 hall element TO92, SOT23 package sensor linearity 1.5 mV/G hall sensor

D2027 piezoresistive flexible film pressure sensor foot pressure force measurement customization

Terminal type Male terminal Female terminal Pressure range 500g 2kg 5kg 10kg 20kg 40kg 60kg 100kg

Original imported 0.2 "pressure sensor FSR400 Force sensitive resistor fsr sensor

M8 photoelectric switch E3F-DS10C4 infrared sensor E18-D80NK obstacle avoidance sensor module normally open

High quality chips Accurate sensing Strong anti-interference ability Stable performance

Smart Electronics RTD Pt100 Temperature Sensor Probe Length 5cm 1/2" NPT Thread w/ Detachable Connector

RTD Pt100 Temperature Sensor Probe Length 5cm 1/2" NPT Thread w/ Detachable Connector Please allow 1-3mm error due to manual measurement. pls make sure you do not mind before you bid Due to the difference between different monitors, the picture may not reflect the actual color of the item

DHT22 digital temperature and humidity sensor AM2302 temperature humidity module

Technical parameter Measuring range Temperature: -40….+80°℃ Humidity: 0...99.9%RH

Original imported flexiforce film pressure sensor A301 1/25/100lbs

The A301 is optimized for high volume manufacturing and ideal for embedding into products and applications. The sensors are available in three force ranges: Low 4.4 N (0 - 1 lb), Medium 111 N (0 - 25 lb) and High 445 N (0 - 100 lb). The force ranges stated are approximations. The dynamic range of this small force sensor can be modified by changing the drive voltage and adjusting the resistance of the feedback resistor.

Force Sensor RP-C18.3-ST Flexible Thin Film Pressure Sensor Intelligent 20g-6kg

The flexible sensor has the characteristics of flexible ultra-thin, ultra-low power consumption and extreme speed response, etc. Small size, this flexible pressure sensor is based on new nanometer pressure-sensitive materials ​supplemented by ultra-thin film substrate. This pressure sensor has the characteristic of high stability, high consistency. Highly sensitive flexible nanometer materials can realize highly sensitive detection of pressure.

Smart Electronics MQ6 MQ-6 combustible gas/liquefied petroleum gas sensor probe dip6

MQ6 MQ-6 combustible gas/liquefied petroleum gas sensor probe dip6

Smart Electronics Hydrogen sulfide sensor probe MQ-136 Toxic gas H2S sensor MQ136

Hydrogen sulfide sensor probe MQ-136 Toxic gas H2S sensor MQ136 The gas-sensitive material used in the MQ136 hydrogen sulfide gas sensor is tin dioxide (SnO2) with low conductivity in clean air. When there is hydrogen sulfide gas in the environment where the sensor is located, the conductivity of the sensor increases as the concentration of hydrogen sulfide gas in the air increases. Using a simple circuit, the change in conductivity can be converted into an output signal corresponding to the gas concentration.

Smart Electronics MQ-9 carbon monoxide Combustible gas sensor alarm module

MQ-9 carbon monoxide Combustible gas sensor alarm module Feature: Size: 32mm * 22mm * 27mm Main chip: LM393, MQ-9 gas sensors Working voltage: DC 5 V Characteristics: 1, having a signal output instruction. 2, dual signal output (analog output, and TTL level output) 3, TTL output valid signal is low. (Low-level signal when the output light can be directly connected to the microcontroller) 4, 0 - 5V analog output voltage, the higher the concentration the higher the voltage. 5, for CO, gas, liquefied petroleum gas with high sensitivity and good selectivity. 6, has a long life and reliable stability 7, rapid response and recovery characteristics Application: MQ-9 sensor main family, environmental detection of carbon monoxide gas for CO, gas, liquefied petroleum gas field testing;
Previous： FSR402 Force Sensing Resistor Long Tail Resistance-type Thin Film Pressure Sensor
Next： Resistive thin film pressure sensor comb type B structure flexible sensor
Return
TOP
86-755-83877216
smartbes
smartbes